A bachelor’s degree in electrical & electronics engineering is a must. Having between 5 to 12 years ofexperience in 132kV and above substation. And familiar with following work.Protection Engineer for Substation who has experiences for the following works;1. Review and Modification for schematic diagrams which shall be provided in Substation.1) GIS/AIS Local Control Cabinet (LCC)2) Control & Protection Panel3) Tariff Metering Panel4) Telecommunication System5) Fault Recorder6) LV AC/DC System including Battery, Charger & UPS7) Others which are required to interface with CRP, SCS and Telecom8) SCS Architecture9) Telecom Network Architecture10) Signal Lists11) IO Mapping List and Data Display for LDC (NCC)12) Cable schedule13) Site Test Procedure and Site Test Form2. Preparation for design and calculation for the below.1) Key Single Line Diagram2) Protection Single Line Diagram3) Logic Diagram (e.g. Inter-lock, Inter-trip, etc)4) CT/VT Sizing Calculation5) (Fixed/Variable) Relay Setting Calculation3. Coordination work with other disciplines related with protection and SCSAdded Advantage:1. Experience with DEWA, FEWA, Transco, Saudi Electricity company (SEC), KAHRAMAA.OETC2. Experience with site test and defective list clearing at site3. Experience with relay logic modification· Qualifications/Requirements· Bachelor's Degree in Electrical & electronics Engineering from an accredited university or college- Willing to travel to Project SiteDesired candidates can share their CVs at Vikas@ (4) Vikas Sharma | LinkedIn
Job Title
Electrical Design Engineer-Substation